Online since 2002. The most comprehensive site for all around twisty puzzles.

Half Cube
Above:Front view
Click a thumbnail to see its larger version and description.
Viewed from one corner it is an ordinary 3x3x3 but from the opposite it is revealed that it is a 3D-printed halved void cube.

This puzzle was first made by the creator in 2010 by hand from a mass produced void cube. In 2011 he presented a CADed version. It shall be noted that it is not the first version where whole section of a void cube were cut away. The first version was presented by David Gugl in April 2010. But there only two sides were left over and the two holes were left open.
Some members of the community even complained about the puzzle being a spoiling creation since it shows the mechanism of the Void cube.



Thank you to the following people for their assistance in helping collect the information on this page: Andreas Nortmann, Lawrence Cuthbert.


This puzzle can be found in collections of these members:

Found a mistake or something missing? Edit it yourself or contact the moderator.
join »login » Community