I typically like to use somewhere between 1mm and 1.5mm on edges that are either on the surface or connected to the surface...
hello, thanks for the advice I will take it and hope to use them as soon as possible;
Hello to all,
the puzzle has been completed, this is my first puzzle printed in 3d, and as the first experience I must say that I was fully satisfied,
unfortunately I have not been able to order a set of stickers, so I was forced to cut them by hand, however the result is excellent (for me);
as regards the work of shapeways, I'm happy with everything except the service of "polishing", i'm too accustomed to my hand polishing,
if I have to name the service would call "less porous" Obviously this is my first puzzle is therefore also possible that something was wrong by me;
ok in a few minutes i will publish photos and video in the new puzzles area, But first I have to eat so: