Just got 4x4x3 from shapeways last weekend, and record a video today.
This sample is just for function testing, the 3D models are not optimized for printing, so it does not look as good as rendering.
Because of the tolerance, it is not very neat in outside appearance.
At first the center part can not be assembled with the cube, I have to cut it off.
There are also some big holes inside the corner parts and edge parts now.
I want to save some money, so did not make them caped.
In final version, they all will be covered.
exploded.png [ 171.38 KiB | Viewed 1162 times ]
443_parts.jpg [ 244.41 KiB | Viewed 1162 times ]
IMG_3255.jpg [ 47.38 KiB | Viewed 1162 times ]
IMG_3257.jpg [ 46.75 KiB | Viewed 1162 times ]
IMG_3258.jpg [ 48.58 KiB | Viewed 1162 times ]
And here is the Video on Youtube