You might've seen the non stickered version in Luke's collection, but now I bring the fully assembled, stickered, ironed puzzle
The mech for this one is reverse spindle, since the edges are very small (the stickers on the edges are 0.5mm wide!!! (and with ironing you can't remove them
There's not much more to say after the mini split domino and Pentagonal domino, except that it extremely smooth (and small
You can buy it at shapeways
for 40$ DIY white or black for a bit more, or fully A&S in black OR white for 60$ including shipping.
Oh, and it's the LAST one of the series.
MSH1.jpg [ 379.25 KiB | Viewed 1004 times ]
MSH2.jpg [ 737.24 KiB | Viewed 1004 times ]
MSH3.jpg [ 712.64 KiB | Viewed 1004 times ]
MSH5.jpg [ 1.56 MiB | Viewed 1004 times ]
MSH4.jpg [ 1.63 MiB | Viewed 1004 times ]
As you asked, here's a picture of after ironing (v2) i know in this zoom it's very visible, but the edge stickers are about 0.7 mm large, and the can't be pulled out !!! (yes it's a BIG zoom)
From a normal eyesight, it's not possible to notice the lines unless the puzzles is less than 10cm from your eyes, so yes: great results!!Video
I hope you enjoy it !